Position Title: QC Inspector
Location: Johannesburg
Time Type: Full time
Requisition ID: JR_29234
Description:
EDUCATION: Grade 12/Equivalent
Qualified Machinist Fitter
EXPERIENCE: 5 Years Experience in machining and fitting /3 years in quality control
REQUIREMENTS: Knowledge of materials and castings/Sound knowledge of pumps assembly
Key Accountabilities:
· Conduct incoming inspection on buyouts, spares received from PVC and repaired and reworked components.
· Inspection of raw materials according to standard supplied as per the order documentation.
· Check documentation received with goods according to KSB order document requirements.
· Conduct component measurements as part of the assembly process when required by fitters.
· Follow up all intervention points as marked up on the pump assembly QCP’s with regards to hold,
verification, witness and review points.
· Conduct final inspection of complete pumps and signoff on quality and assembly documentation for final
release.
· Check all documentation that has been completed and complete the final QC Checklist before signing off.
· Markoff heat numbers, order numbers, and material on components were required.
· Perform non-destructive testing on components as defined by the instructions and standards and generate
certificates and reports for tests prior to conducting the following:
· Liquid penetrant test.
· Magnetic particle test.
· Hardness test
· Surface roughness testing for sandblast components.
· Paint coating thickness test.
· Attend pressure testing on pumps and valves and conduct inspection as per the assembly job specification
QCP.
· Attend and witness balancing of impellers at supplier premises as and when required.
· Attend and witness performance tests at supplier premises as and when required.
· Conduct site inspections with respect to dimensional and geometrical tolerances.
· If a defect is found, record on NCR form and send a copy to Planning Department and Supervisor.
· Conduct in process inspection on machines during machining on various items. (1st off)
· Conduct Final inspection of final machined item supplied from production machine shop.
· Conduct 3D measuring and scanning on various items as per QCP and manager / supervisor instruction.
· Confirmation of final machined items.
· Identify root cause of error on production line.
· Identify casting defects during Production machining process.
PI284500020